Xerox 2006NPC - DocuColor Color Laser, User Manual

Page: 491 / 574

Network Problem Solving 24. Problem Solving
Xerox DocuColor 2006 24-43
Network Problem Solving
Because the DocuColor 2006 server is part of the Printer, most references in
this chapter are simply to the Printer. The word server is used to refer to
network servers.
Problems during Setup from the Control Panel
If you have difficulty printing the test page and no message is displayed,
perform the following steps:
1. Check the Printer status.
2. Use the table below to attempt to resolve the problem.
3. Try printing again.
Symptom Possible cause Possible solution
The power switch has
not been switched on. Switch ON the Printer
power switch.
The power cord is not
securely attached. Ensure that the power
cord is securely plugged
into the wall and into the
Printer.
None of the control
panel lights are on.
Nothing is displayed on
the Control Panel
screen.
There is no power to the
electrical outlet. Ensure that the outlet is
switched on.
The interface cable is
not connected properly. Ensure that the network
or parallel cable
connector is properly
attached. The data does not light
when a print job is sent
over the network or the
parallel connection, or a
copy job is in progress.
Either the print driver is
not installed or a server
has not been correctly
set up. Check the settings on the
host server.