Xeo4 RILHEVA II, User Manual

Page: 14 / 35

14
DEVICE CONFIGURATION VIA SMS
For the Rilheva device being fully operating, it has to be correctly configured. The following operations
must be executed:
1) Enter a valid SIM card (having GPRS service 2G/3G enabled) into the dedicated slot while the device is
powered off .
Important: make sure that the PIN code is disabled for the SIM card used with Rilheva . If not, insert the
SIM card into a GSM phone and follow the procedure to disable the PIN, ensuring that it will not be
requested anymore.
Important: please disable all value added services that might be provisioned from your mobile operator
and that may cause the sending of SMS messages to the SIM Cards.
2) Power-up the device
After few seconds, the 3 LEDs will blink at the same time, indicating that the device is waiting for the first
configuration (e.g. configuration SMS message or web settings).
3) You can send an SMS configuration message to the device (using the SIM number installed) this way:
A**[IMEI code]**[cloud server host/IP]**[cloud server port] **[provider APN]**
[username]**[password]
[IMEI code]
this serial code (15 digits) is printed on the device
label
[ cloud server host/IP] engine2.xeo4.it
[cloud server port] 8081
[provider APN]
depending on the GSM provider, the suggested APN
must be specified.
Please contact the
provider in order to
obtain further
information
[username] Only if requested, otherwise write “NO”
[password]
Only if requested, otherwise write “NO”
SMS message example:
A**011013006419300**engine2.xeo4.it**8081**web.omnitel.it**NO**NO**