XS26GS Managed Optical Ethernet Switch User Manual
56
【
Ctrl
】
+
【
c
】
Skip the current command and go to a new line.
Page shortcuts list:
Shortcuts
Explanation
Any key except
【
Enter
】
and
【
q
】
Shows the next page.
【
q
】
Stops the displaying.
【
Enter
】
Shows the next line.
3.4
CLI Command Modes
These are the view modes for the switch:
z
User view
z
System view
z
Ethernet port view
z
Port-based VLAN view
z
VLAN view
z
dot1x view
z
mst-region
The “Any view” in the below table refers to any one of the following: System view,
Ethernet port view, Port-based VLAN view, VLAN view, or dot1x view.
Command
Mode
Access Method
Prompt
Exit Method
User view From System view, enter
the
disable
command.
XS>
To back to System
view, enter the
enable
command.
System
view
This is the top level of
access.
XS#
To enter into User
view, enter the
disable
command.
Ethernet
port view
From System view, specify
an interface by entering the
interface ethernet
command followed by
interface identification.
XS(Ethernetx/x)#
To exit to System
view, enter the
end
command, or
press
Ctrl-Z
Port-base
d VLAN
view
From System view, specify a
vlan id by entering the
port-based-vlan
command followed by a vlan
id.
XS(port-based-vlan-x)# To exit to System
view, enter the
end
command, or
press
Ctrl-Z
VLAN
view
From System view, specify a
vlan id by entering the
vlan
command followed by a vlan
id.
XS(vlanx)#
To exit to System
view, enter the
end
command, or
press
Ctrl-Z
dot1x
view
From System view, enter
the
dot1x
command.
XS(dot1x)#
To exit to System
view, enter the
end
command, or
press
Ctrl-Z
ACL view From System view, enter
the
acl number
command,
there are three prompts.
XS(ACL-basic-x)#
XS(ACL-advanced-x)#
XS(ACL-L2-x)#
To exit to System
view, enter the
end
command, or
press
Ctrl-Z