7
1.
If necessary, remove the pen cap.
2.
Remove the original brush by gently pulling on the metal ring connected to the bristles.
3.
Insert the replacement brush until it is fully installed. Be careful not to damage the bristles.
Installing the IR Receiver
The touch system works with an IR receiver and a metal bracket or strip that mount to your monitor’s bezel.
The adhesive on the back of the metal bracket or strip is not designed to be reattached. Try
testing the optimal position by holding the IR receiver in place halfway down the left side of
your monitor’s bezel while you calibrate the screen. This way, you will be able to determine
whether the IR receiver can read the entire surface of the screen.
If you touch one of the calibration points with the pen and nothing happens, adjust the IR
receiver’s position higher or lower on your monitor’s bezel. See
Calibrating the Screen
on page
10 for instructions on how to calibrate your screen. Also, make sure the IR receiver’s USB cable
can reach your computer’s USB port.
WTP Manual.indd 7
12/20/13 9:54 AM
