Xantrex Truecharge TC1012, Owner'S Manual, Page: 59 / 80

Replacing the DC Output Fuse
975-0401-01-01 3–11
Replacing the DC Output Fuse
To replace the DC Output Fuse:
1. Disconnect all AC and DC sources to the charger.
2. Locate the fuse cover on the charger’s top panel (see
Figure 1-1, “Truecharge™ 2 Battery Charger” on page
1–4).
3. Loosen the screw on the fuse cover using a Phillips
screwdriver.
NOTE: The screw will not separate from the cover.
4. Pull out the blown fuse(s) gently, using the provided fuse
puller.
NOTE: The fuse puller is located on the inside of the
cover.
5. Install a brand new fuse(s) with same type and rating as
the old one.
NOTE: Choose Littlefuse type 257 or equivalent.
6. Replace the fuse cover making sure that it aligns and fits
perfectly leaving no space for moisture or small debris to
enter the compartment.
7. Tighten the screw on the fuse cover but do not over-
tighten.
8. Reconnect all AC and DC sources to the charger.
TC2 Series BattChg Owners Guide.book Page 11 Tuesday, July 1, 2008 11:55 PM