Xantrex Freedom XC2000-230V, Owner'S Manual, Page: 56 / 106

Basic Installation Procedures
40 Freedom XC 2000 - 230V Owner's Guide
Description of Ignition Control Features
For information about the features and instructions on changing
the ignition control features, see
Operation on page 45 .
Ignition Auto-
on ( ATO )
This setting allows the inverter/charger to
operate (Battery mode) automatically
when an ignition control wire is connected
to the ACC input and a valid ignition
signal is constantly detected. The inverter
works in tandem with the vehicle’s ignition
circuit.
Ignition Lock-
out ( LOt )
This setting allows the inverter/charger to
operate (Battery mode) when an ignition
control wire is connected to the ACC input
from the ACC and a valid ignition signal is
constantly detected.
When enabled, you have to manually
press the Power button on the display
panel to operate the inverter/charger.
Off ( OFF )
To completely disable the ignition control
features do the following:
Set Ignition Control to Off ( OFF ) using the
Select buttons on the Display panel.
Table 9 Ignition Control Features
Connecting to the Remote Port
The Freedom XC can accommodate the Freedom X Remote
Panel with cable (PN: 808-0817-01) (sold separately; comes with
7.6m-cable) or the Freedom X Remote Panel unit (PN: 808-0817)
(sold separately; unit only without cable).
To connect the remote panel to the remote port:
n
Plug the remote panel unit's cable connector to the RJ12
Remote port on the unit.
NOTE : When the remote panel is connected, turn the
inverter/charger’s Power button to the Standby mode (up
position). This allows the remote panel to control the
inverter/charger’s power status.