Xantrex Freedom XC2000-230V, Owner'S Manual, Page: 46 / 106

Basic Installation Procedures
30 Freedom XC 2000 - 230V Owner's Guide
8. Connect each AC wire into its corresponding terminal on the
no-tool cage clamp terminal block.
a. Lift the terminal lever (as shown in the previous figure).
b. Insert the wire fully into the open slot.
c. Lower the terminal lever to secure the wire in the slot.
9. Make sure that each AC wire is matched and connected to
the Neutral ( N ), Earth ( G ), and Line ( L ) connections.
10. Tighten the strain relief clamp to secure the wires.
11. Replace the wiring compartment cover onto the unit (using a
#2 (3.5mm) Phillips torque screwdriver - see WARNING), if
you are not connecting other wires such as for the AC
Output. Otherwise, keep the AC compartment open and
proceed to the next step.
WARNING
ELECTRICAL SHOCK HAZARD
Use a torque screwdriver to tighten the captive nut panel screw to
0.56 N-m torque of force to ensure a proper earth connection and a
required tool access to the wiring compartment.
Failure to follow these instructions can result in death, serious
injury, or equipment damage
.
12. Connect the other end of the wires to the circuit breaker in
the AC distribution panel supplying AC power to the unit.