Commercial SmartPad LCD
¥
Page:
11
© 2006 Xantech Corporation
6. IR Learning Eye LED.
Brightness indicates strength of Teaching remote to CSPLCD IR Learning
sensor
7. RS232
Com
Port.
3 Pin Header. Used to program the SmartPad LCD from a PC using Universal
Dragon Drop-IR™ Software and for Firmware Upgrades.
8. RESET
Button.
Depressing button with blunt object will recycle CSPLCD to initial POWER ON state
9. USB Com Port.
Used to program the SmartPad LCD from a PC using Universal Dragon Drop-IR™
Software and for Firmware Upgrades.
10. LCD Backlight Adjustment.
Adjusts brightness of LCD backlight. Slowly turn counter-clockwise to
reduce brightness.
11. LCD Contrast Control.
Adjusts Contrast of CSPLCD screen. Slowly turn clockwise to increase
contrast of images on LCD screen.
12. Bezel Mounting Clips (4).
Guide clips for mounting Front Bezel onto CSPLCD Display
SPLCD
19
18
20
14
16
17
13
15
21
IR BUS
IR IN
ZONE
CONTROLLER
EXPANSION
SERIAL
GND
IR OUT
+16V IN ONL
Y
GND
ST
ATUS
IR BUS
+12V OUT
GND
GND
IR IN
+12V OUT TO EXPANSION
IR RECEIVER ENABLE
TERMINATION
SMARTPAD LCD
GRAPHIC TOUCHPANEL
IR RECEIVER
CAUTION:
SPLCD ONLY!
DO NOT CONNECT
12V DEVICE
Figure 3 –
SmartPad LCD
¥
– Rear Panel Connections and Functions
(Model CSPLCD39G Displayed)
CSPLCD REAR PANEL FEATURES AND CONNECTIONS:
13. Controller Terminal.
RJ45 Jack. Connects Keypad to zone keypad input on CM8X8/MRC88 Controller
via CAT5 cable.
14. Expansion Terminal.
RJ45 Jack
.
Allows keypad to be daisy chained to another keypad for multiple
control locations within a zone. Up to 4 keypads are supported per zone.