30
How To Test Motor Direct To Battery
**ATTENTION: Prop the scooter up so that the rear wheel is NOT touching
the ground. In this test the drive wheel will run full speed.
1.
Access the Battery and Controller compartment.
2.
Locate the Connector from the Battery to the Controller and label
the male & female sides for reference.
3.
Locate the Connector coming from the Motor to the Controller and
label the male & female sides for reference.
4.
Unplug the Battery and Motor connectors and plug them directly
into each other.
**Caution** This will bypass the controller and put power directly to the
motor.
If the Motor is good and the Batteries are charged the wheel will spin at full
power in which case the Controller may need to be replaced.
If the Motor did not run then the Batteries will need to be checked to confirm
they are holding a charge.
If Batteries are holding a charge then the Motor will need to be checked or
replaced.
How To Replace Throttle
1.
Open the footplate. Run the new throttle wires down to the battery
compartment. Find the white connector on the controller marked
“throttle”.
2.
Disconnect this white connector. Mark the color of the wires on the
white connector so you can insert the new wires in the correct place.
3.
Look down inside the white connector that goes to the throttle, you
will see metal pins. The pins are held in place by a small tab that
bends outward. Reach inside the front of the connector with a dental
Summary of Contents for XB-420M
Page 40: ...39 ...
Page 41: ...40 Wiring Diagram See notes above ...
Page 42: ...41 Controller Wiring Diagram ...
