14
ASSEMBLY AND SETUP
1)
With the cardboard, steel frame top & sides, and packing material
removed you are ready to begin assembly. The tools needed for setup are
included in the XB-420M tool kit (located in the compartment under the
seat).
2)
Attach the front wheel:
a.
Remove the Axel Bolt from the Front Fork from where
it is attached to the steel frame base (be careful not to
loose the carter key as you will be reusing it).
b.
Place a solid support about 10” high under the floor
board section to raise the front of the scooter just
enough to easily install the front wheel. Recommend
two people to raise XB-420m.
c.
Slide the brake assembly (that is hanging down) into the
wheel cavity.
d.
Position the wheel between the forks with the spacer on
the side of the wheel that does not contain the brake
assembly.
e.
Slide the axle bolt through the center of the wheel hub.
f.
Tighten the nut on the axle bolt and insert the cotter
(safety) pin.
g.
Inflate the front and rear tires to 35 psi.
h.
With front wheel installed lift and remove the spacer
under the floorboard.
i.
Remove the wire ties holding the two rear wheels and
roll XB-420m off of steel frame.
3)
To make sure the alignment is correct, stand in front of the vehicle,
using both legs to hold the front wheel in a straight-forward position.
Use both hands to grab the handle bar and turn it into normal driving
position (90 degree angle from the front wheel).
4)
Attach the Rear View Mirrors into the mounting holes and carefully
screw on. Use a wrench to tighten the lock nuts at the base of each
mirror when aligned.
5)
Check if the brakes are properly adjusted. The brake handles should
stop short of touching the handgrip, when fully engaged. The rear brake
cable can be adjusted in two places:
Summary of Contents for XB-420M
Page 40: ...39 ...
Page 41: ...40 Wiring Diagram See notes above ...
Page 42: ...41 Controller Wiring Diagram ...
