X-Trax VP-1003, User Manual, Page: 11 / 60

- 11 -
the screen will show “ WAN
”.
2.
Press "OK" or Soft2 (Enter) to show “ Net Mode
”. Select “
DHCP
”. Press Soft2 (Save), with
“
saved
” shown, screen will jump to show the current net mode.
3.
Press or Soft3 (Quit) thrice back
to main interface and at this time phone is
trying to change to DHCP mode
. Press until the phone shows “ DHCP
”
，
If the
screen shows the IP address and gateway which were set just now, it shows that DHCP mode
takes effect.
3. VP-1003’s basic operation
3.1. Answer calls
VP-1003 will ring to indicate you when there is call incoming
，
below is ways to answer call
：

Answer with hook off
Take handset, you can talk directly. You can just hang up to finish talk
。

Answer with hands-free
Press to begin talking. Press again to finish talk

Answer with headset
Press to answer the call, if the phone detect headset LED will turn to green, when you press
again the phone change to speaker mode. You may press or Soft3 (Close) to
finish the call.

Using hands-free instead of handset during a talk
Press and hook on the handset when you use handset to speak and want to change to use
hands-free to speak. Press again to finish talk.

Using handset instead of hands-free during a talk
Hook off the handset when you want to use hands-free to speak and want to change to use handset.
Just hook on to finish talk.
3.2. Place calls