13
Setting Up the SpectroProofer
|
13
For the 44" model, attach the first backing plate on the right side of the
printer, then attach the second backing plate to its left. Make sure the
plates hook together as shown. Ensure that both plates rest flush against
the printer and don’t move when you try to slide them.
5. Insert the calibration tile into the holder. Remove the cover on the back
of the holder by rotating it. Drop in the tile with its white surface
face-down. Replace the cover.
Caution:
Do not touch the white
surface of the tile.
Summary of Contents for SpectroProofer
Page 1: ...Setup and Maintenance ...
Page 4: ... 4 4 Contents ...
Page 6: ...6 6 Introduction ...
Page 20: ...20 20 Setting Up the SpectroProofer ...
