M A - T 6 / M A - T 1 2 S P E C T R O P H O T O M E T E R
7
Installing the Battery Pack
Your new instrument is shipped from the factory with the battery pack removed
. Two battery
packs (one is a spare) are located in the instrument case and should be charged before use. Refer
to "Charging the Battery Pack" later in this section for charging details. The instrument will also
operate from the AC adapter without a battery pack installed.
1.
Carefully turn the instrument over and slide open the latch (1) that secures the battery pack
access cover. Open the access cover.
2.
Slide the new battery pack (2) into the instrument with the battery contacts facing down until
the battery is positioned below the holding latch (3).
3.
Close the access cover by pressing down until it locks into position.
Use the rechargeable Li-ion batteries provided (X-Rite P/N SE15-40 / E-One Moli Energy Corp Model
MCR-1821J/1-H); other types may burst causing personal injury. Replacement batteries can be purchased
from your authorized X-Rite representative or E-One Moli Energy Corp
.
Powering On
The power/measure button is used to initiate the instrument from a power
off state. Simply press the button (1) to turn on the instrument. If the
instrument does not power up after pressing the power button, the
batteries may require charging.
Refer to Charging the Battery Pack
. The
instrument is also powered on by plugging the AC adapter into an outlet.
Powering Off
The instrument can be manually powered off by pressing and holding the power
button for three seconds and tapping
Power Off
, or by using the Settings menu.
When first powered up, the instrument goes through a diagnostics test
and displays a splash screen before the main screen appears.
Splash Screen
Main Screen
(1)
(1)
(2)
(3)
Summary of Contents for MA-T12
Page 1: ...MA T6 MA T12 Spectrophotometer User Guide ...
Page 2: ......
