Tel. +49 (0) 86 41- 69 48 - 60 | www.x-gloo.com | [email protected]
Procedure in the case of pressure loss:
• FIRST close all Valves TIGHTLY!
• If pressure loss continues, blow out the Overpressure Valves to
remove all dust or dirt particles.
• If pressure loss still continues, the quickest solution is to remove
the Bladder and replace it, as a damaged Bladder is likely the cause.
- If the damage is visible on the Bladder and the damaged
area is smaller than 1 cm -> Apply the Adhesive Repair Patch
included in the Repair Kit.
- If the damaged area cannot be found, spray some soap suds
onto the inflated Bladder surface so that the escaping air
bubbles are visible and the damage can be located. Then
apply the Adhesive Repair Patch to repair the Bladder.
STORAGE
• Avoid pressure spots (e.g. do not lean on the tent with your
knees while folding the tent up).
• Store the X-Gloo in a dry location and at temperatures not
exceeding 40° celsius.
• Do not pack or store the X-Gloo when damp or wet, since this
can cause the formation of mold spots and discoloration.
• At temperatures lower than 0° celsius, folding can lead to
damage of the components. Take special care with the Window
Walls in low temperatures and pack them carefully.
• Never store the X-Gloo in an automobile in direct sunlight.
The intense heat can cause the Window Walls to stick together
irreversibly, or may cause permanent damage to the cloth.
Important information for digitally-printed parts!
Digital printed elements must be stored in dry condition!
CAUTION:
If the elements are stored while still damp, the
ink from the printed material can bleed and the printing can
become permanently damaged! We are unable to accept liability.
MAINTENANCE, CLEANING, REPAIR
All kinds of repairs can be done in our workshop in Marquartstein
or in the Service Center in Las Vegas, Nevada. We can also take
care of special requests (additional straps, velcro strips, etc.) at
our facility.
• Maintenance and repair should be carried out only by X-GLOO or
by an authorized Service Center.
• The X-Gloo should be periodically inspected for chafe marks and
damage and promptly repaired.
• In order to avoid damage of the material coating, first attempt
to remove dirt and stains using a soft, dry brush or microfiber
cloth. Only if necessary use a small amount of mild alkaline
solution mixed with water. Avoid the use of solvents, washing
machines or steam cleaning.
• Re-waterproofing is not possible.
MATERIALS
• Bleaching of the material is possible with extended UV
exposure (e.g. at high altitude or extended setup time). White
wall material tends to yellow from UV exposure, and is easily
stained when contacted with dust and dirt. All of the materials
currently implemented in the X-Gloo have been subjected to
extensive material testing. It is practically impossible to state
when exactly a color change could become visible, since the
influencing factors vary strongly. However: All cloths change
in color with extensive UV exposure! According to expert
knowledge, with proper care the X-Gloo will show only minimal
color change after many years of use. The range of use will not
be limited.
• The materials used (and therefore, the entire tent) are
waterproof.
7
!
