X – 60 Instructions Version 1.0
Page 27
C8)
X – 60 control arms and toe-in bars have
been designed for about .060” of shims.
Your AE shims are about .030, so the
arms can go forward, middle, or back.
Team drivers rarely space the arms
forward, and they like having a shim
between the arm and the bushing.
C9)
Your X – 60 has been supplied with two
toe-in bars, 3 degrees and 4 degrees. Check
the Tuning Section and Set-Up sheets to
determine which you will use. Engage the
rear of the hinge pins in their holes in the
toe-in bar. The bar will extend across the
back of the chassis.
C10) Secure the toe-in bar with two 4-40 X ¾”
cap head screws and flat washers (small
arrows). Leave the screws finger-tight for
now. The bar must be free to move up
and down in its slots and there should be
a gap between the bar and the chassis
(large
arrow).