X – 60 Instructions Version 1.0
Page 14
A5)
Gather the idler gear (9360) from your T4, the idler gear from Bag A, the two
3/8 X 3/16 bearings (6906) from your T4 and the two 3/8/ X 3/16 bearings from
Bag A (left photo) Install two bearings in each idler gear, one from each side.
(center) If a bearing is hard to install, we suggest a socket where the OD of the
socket matches the diameter of the outer race of the bearing so you do not push
on the balls or the inner race. (right)
A6)
Slide the idler shaft (9361) through the bearings in one idler gear and the idler
shaft from Bag A through the other. Then install the shafts with the two gears
into their bosses in the left transmission case. Be certain to mesh all the gears
properly.
A7)
Insert the diff through the outdrive bearing in
the left transmission case half. The head of
the diff screw should be up (arrow). Make
sure all the gears are properly meshed and the
trans rotates freely.