X – 60 Instructions Version 1.0
Page 22
B5)
NOTE:
Tolerances are tight where the
chassis mates with the bulkhead.
Most bulkheads fit OK, but some are
slightly oversized in one small spot. If
you have one of these, please lightly
run a file over the back inside corners
of the chassis’ transmission “box” to
ensure proper fit.
INSTALL THE TRANSMISSION
B6)
Place the assembled transmission and motor plate in its box. It should be a snug
fit but should slide up and down without too much force. Check that nothing is
catching. The motor plate should be snug against the right side of the motor
plate support.
B7)
Remove the transmission from the truck.
Check the Tuning Section and Set-Up sheets
to determine how high you will mount your
transmission and select the proper shims
from the bag of shims. Assemble three 4-40
X 5/8” cap head bolts, one 4-40 X ½” button
head bolt, four flat washers, and the shims.
Note that the short button head screw will be
at the left front (arrow).