Würth 0715 54 100, Operating Instructions Manual

Page: 6 / 36

6
Working safely with this machine
is possible only when the operat-
ing and safety information are read
completely and the instructions con-
tained therein are strictly followed.
Do not make structural changes to the equip-
ment.
The trolley jack is intended only for the lifting of
loads but not for supporting. Working on or un-
der lifted vehicles is allowed only after they have
been secured against tipping over, rolling away
or sliding off and supported with blocks.
The trolley jack may be used only on level and
firm surfaces.
●
●
●
The distance to walls, doors and firm structures
must be more than 0.5 m to allow for escaping in
case of danger.
The vehicle should not be lifted when damage to
the vehicle could result from fuel, battery acid or
other harmful fluids.
Lift the vehicle only at lifting points recommended
by the manufacturer.
When malfunctions occur, do not operate the
trolley jack.
During lifting, persons are not allowed to remain
in the vehicle.
●
●
●
●
●
Art.-No. 0715 5 100 0715 5 10 0715 5 150 0715 5 160
Type RHC-2 RHC-2H RH-4 RH-6
Lifting force 2000 kg 2000 kg 000 kg 6000 kg
Height min. / max. 80/500 mm 98/735 mm 15/560 mm 150/570 mm
Weight 36 kg 53 kg 70 kg 90 kg
Quick lift
✔ ✔ ✔ ✔
Hydraulic oil:
Castrol Hyspin AWS 22 / Shell Tellus HLP - HM 22/ BP HLP 22 / Esso Univis N 22 /
Mobil DTE 22 / Elfona DS 22 / Fina Hydran LZ 22
Positioning the Lifting Arm E to Working
Height
Operate the foot pedal C to activate quick lifting.
Pump with maximum stroke to bring the support plate
D quickly to the working height.
Lifting of Loads
The optimum force transfer is achieved with short
pumping strokes. Take care that the support plate is
securely seated.l
For vehicles that are too heavy, the overload valve
opens and lifting is not possible.
Do not continue to pump when the trolley jack is at
the highest position.
Lowering
Pull the handle and turn to the right to open the lower-
ing valve; the lowering speed can be regulated with
the angle of turning.
●
●
●
●
●
●
Tool Specifications
Legend
A Handle for moving and jacking
B Knurled screw
C Foot pedal
D Support plate
E Lifting arm
Mounting
Operation
Loosen the knurled screw B on the side of the handle
holder somewhat. Insert the handle A and tighten the
knurled screw until it engages in the slot of the handle.
The handle must be capable of being pulled out by ap-
prox. 2 cm and turned.
Handle functions
Pulled and turned = Lowering
Not pulled = Lifting
GB
For your safety