G-13
RCK54/60-24B-EC · RCK60-27B-EC · RC60-24/27BR, WSM
G GENERAL
Mid Hanger Bracket
1. Screw M12 stud bolts (1) in the clutch housing.
2. Attach the mid hanger brackets (2) to the clutch housing with
spring washers and nuts.
W1029421
Rear Hanger Bracket (Lift Cylinder Type)
■
B1710, B2110 and B2410
1. Assemble the lift cylinder kit as shown in figure.
2. Apply grease to the cylinder joint pin (4), (5) and lift shaft (1).
3. Apply seal tape to the cylinder adaptor (2) and set the direction
as shown in figure.
Tighten the cylinder adaptor with specified torque then rotate
(clockwise) the adaptor to set the specified direction.
4. Set the cylinder rod flat face toward the RH side of machine.
W1015981
Tightening torque
Stud bolt
31.4 N·m
3.2 kgf·m
23.1 ft-lbs
Nut
68.6 N·m
7.0 kgf·m
50.6 ft-lbs
(1) Stud Bolt
(2) Mid Hanger Bracket
(A) Outside (Round End)
(B) Inside (Flat End)
(C) Thread Size : M12 x Pitch 1.25
(D) Thread Size : M12 x Pitch 1.75
(E) RCK54-24B-EC, RCK60-24B-EC,
RC60-24BR
(F) RCK60-27B-EC, RC60-27BR
Tightening torque
Cylinder adaptor
24.5 N·m
2.5 kgf·m
18.1 ft-lbs
(1) Lift Shaft
(2) Cylinder Adaptor
(3) Cylinder
(4) Joint Pin
(5) Joint Pin
A : 1.57 rad. (90 °)
KiSC issued 11, 2006 A
