Assembly
3730 E. Southern Avenue, Phoenix, AZ 85040 USA
800-778-8779
Workhorseproducts.com
9
1.
1.
1.
2.
2.
2.
2. After the infeed roller is bolted back into place, turn the dryer on with a belt speed of 100% and let run for 5
minutes. You will be able to see if the belt is tracking correctly. If the belt is not tracking properly, use the bolts for
the tension roller on the infeed side of the dryer. If the belt is moving left, use the right bolt and make a 1/4 turn right
and watch the adjustment. Continue the process until the belt has tracked correctly. Make the same adjustments on
the other side of the dryer if the belt is moving to the right. When completed, the belt should be tracking underneath
both tracking plates without moving to one side or the other.
1. Once the belt is pinned together, you will need to reinstall the nuts and bolts for the infeed roller. Move the roller
bearing back into place so that the bottom bolt and top bolt are aligned. The bolt will go into the bearing from the
roller side of the arm and the nut will tighten down on the outside of the arm.
Step 3: Installing and Tracking the Belt
Parts needed:
Belt
Threading Pin
