Assembly
Step 2: Attaching the Outfeed
Tools needed:
9/16” Socket
Wrench
9/16” Wrench
3730 E. Southern Avenue, Phoenix, AZ 85040 USA
800-778-8779
Workhorseproducts.com
7
1. The outfeed arm (the arm with the cooling
table), must be attached to the side opposite of
the tablet. Insert a hex bolt and washer into the
four holes where the arm will connect. Make sure
the hex bolt is facing out and exposed.
2. With another person and two flanged nuts in
hand, lift up the outfeed and insert it into the four
exposed hex bolts.
3. While holding the outfeed, hand tighten the nut
to the top hex bolt first. Hand tighten a second
nut to the bottom hex bolt. Be sure to do step
three on both sides simultaneously.
4. Using the 9/16” wrench on the top of the bolt
and the 9/16” socket wrench on the nut, tighten
all four hex bolts.
Parts needed:
Infeed Arm
4 x
Hex Bolt (3/8-16 x 3/4”)
4x Flanged Nuts (3/8-16”)
4 x Flat Washers
