Assembly
3730 E. Southern Avenue, Phoenix, AZ 85040 USA
800-778-8779
Workhorseproducts.com
6
Step 1: Attaching the Infeed
Parts needed:
Infeed Arm
4 x
Hex Bolt (3/8-16 x 3/4”)
4x Flanged Nuts (3/8-16”)
4 x Flat Washers
Tools needed:
9/16” Socket
Wrench
9/16” Wrench
2. With another person and two flanged nuts in
hand, lift up the infeed and insert it into the four
exposed hex bolts.
3. While holding the infeed, hand tighten the nut
to the top hex bolt first.
The top hex bolt needs
to be done first because it relieves weight from
the top.
Hand tighten a second nut to the bottom
hex bolt. Be sure to do step three on both sides
simultaneously.
4. Using the 9/16” wrench on the top of the bolt
and the 9/16” socket wrench on the nut, tighten
all four hex bolts.
1. The infeed arm (the arm without the cooling
table), must be attached to the side with the
tablet. Insert a hex bolt and washer into the four
holes where the arm will connect. Make sure the
hex bolt is facing out and exposed.
