
47
48
ATTENTION
The brake lever must not touch the handlebar grip, even when applying maximum
strength. Only unscrew the adjusting screw counter clockwise so that the brake lever
does not touch the handlebar grip, even when the brake is applied with maximum
strength. Never unscrew the adjusting screw completely from the handlebar grip.
Shifter spacing
The default shifter position is set according to the woom OFF model.
To change the shifter position, loosen the shifter clamping screw with a 5 mm hex key and
position the shifter according to your child's requirements. After positioning the shifter,
tighten the clamping screw to the tightening torque specified in Section 11.1 on page 56.
Make sure that your child can reach the shifter easily and effortlessly with his or her thumb.
Handlebar tilt
See also „Mounting the handlebar“ on page 41.
6�4 Suspension fork (woom OFF AIR)
The woom OFF AIR comes with preset air pressure. If you want
to adjust the air pressure, please proceed as follows: To adjust
the correct air pressure in the air suspension fork you need a
special absorber pump. First remove the valve cap (see figure)
from the upper left end of the air suspension fork by turning
it counter clockwise. Fill the suspension fork with the correct
air pressure according to your child's body weight (see table).
Screw the valve cap back onto the valve.
20˝
24˝ and 26˝
Body weight (kg)
Air pressure (psi)*
Body weight (kg)
Air pressure (psi)*
<20
20-25
20-30
40-50
20-25
25-30
30-45
50-65
25-30
30-35
45-65
65-85
30-35
35-40
>65
85-100
*max. permissible air pressure: 150 psi
Adjusting rebound damping
Rebound damping and the rebound speed of the air suspension
fork can be adjusted with the red knob at the lower right end of
the fork. To increase the rebound speed and reduce rebound
damping, turn the red knob in the + direction. To reduce the
rebound speed and increase rebound damping, turn the knob
in the - direction. In order to adjust the rebound damping to the
needs of your child, please read the information on damping
adjustment in this section.
Loosen the screws of the stem
clamps a little.
Adjust the tilt of the handlebar.
Tighten the screws alternately
until all are firmly tightened
again.
ATTENTION
Make sure that the handlebar is in the middle! The marking on the front helps to
ensure this.
Make sure that the clamps do not tilt and are evenly seated.
Make sure that the handlebar cannot be turned when the screws are tightened.
4 mm
4 mm