Woods BRUSHBULL BB600XE, Operator'S Manual

Page: 18 / 134

18 Dealer Service
MAN1255 (3/19/2018)
CROSSBAR INSTALLATION
Using emery cloth (220 or finer), remove surface rust, Loctite
®
and for -
eign material from hub, splined gearbox, vertical shaft, and crossbar as
shown in Figure 20.
Figure 20
Refer to Figure 21
.
8.
Install crossbar (2) on splined shaft. Install washer (5) and nut (3). Torque
nut to 610.1 N-m (450 lbs-ft).
9.
Install cotter pin (4) (supplied) through gearbox shaft and slots in nuts.
Twist end of pin around nut (3).
Figure 21
UNIVERSAL JOINT REPAIR
Figure 22
. U-Joint Exploded View
U-Joint Disassembly
1.
Remove external snap rings from yokes in four locations as shown in
Figure 23.
Figure 23 .
Remove Snap Ring
2.
With snap rings removed, support drive in vise, hold yoke in hand and tap
on yoke to drive cup up out of yoke. See Figure 24.
Figure 24 .
Remove Bearing Cups
3.
Clamp cup in vise as shown in Figure 25 and tap on yoke to completely
remove cup from yoke. Repeat Step 2 & 3 for opposite cup.
1. Yoke
2. Bearing cup
3. Retaining ring
4. Bearing cross