BA_WP_SPM2-1000_EN_28-22.docx
48
19
Maintenance and Inspection
Before carrying out any maintenance and inspection work, chapter
“Safety”
must be
read carefully and observed!
Breakdowns caused by inadequate or improper maintenance can result in very high repair costs and long ma-
chine downtimes. Regular maintenance is therefore essential.
Switch off the machine during all maintenance and repair work and secure it against being
switched on again unexpectedly! Lock the main switch with a padlock!
Due to the different operating conditions, it is not possible to determine in advance how often a wear check,
inspection or maintenance is required. Appropriate inspection intervals should be determined considering your
operating conditions.
19.1
Cleaning
Regular and thorough cleaning guarantees a long service life of the machine and also contributes to safety.
•
After each work shift, the machine and all its parts must be thoroughly cleaned by thoroughly removing dust
and chips from the surfaces of the machine table, the safety fence and the sliding table, as well as from the
machine interior.
•
Clean all moving parts every week with turpentine or other suitable and safe solvents.
•
Take special care to thoroughly clean all guides as well as the ruler support for the telescopic fence and the
T-slots in the sliding table and clean them with a soft brush and turpentine or other suitable and safe sol-
vents.
•
To remove dust and chips, clean the machine's belts with a soft brush approximately every 500 hours of
operation.
Avoid cleaning with compressed air, as the wood dust produced can penetrate the bearings and
guides of the machine and is also distributed in the workshop!
19.2
Lubrication
The machine was subjected to a test run at the factory for a longer period of time and was already lubricated
ready for operation. Relubrication before commissioning is therefore not necessary.
•
Clean all sliding/rolling parts weekly and check for smooth running. If necessary, lubricate with a thin oil.
•
Apply a few drops of oil weekly to the threads of clamping and adjusting levers.
•
When lubricating parts in the interior, cover the belt and pulleys to avoid contamination by oil and grease.
Lubricate the machine only with special grease, e.g.
•
ARCANOL BN 102
•
CALIPSOL H442B
•
Shell Gadus S2 V100 3 (formerly SHELL Alvania 3)
For oil lubrication we recommend:
•
Motor oil type 20 W 40
Always use the same grease/oil.
