BA_WP_SPM2-1000_EN_28-22.docx
44
17
Optional Accessories
17.1
Protective and Pressure Device GAMMA
V 1629
The protective and pressure device type GAMMA V 1629 can be attached to all common safety fences and is
used instead of the standard protective and pressure device. It is infinitely adjustable horizontally and vertically
and locks in the folded-up position.
Figure 26: Protective and pressure device GAMMA V 1629
•
First adjust the safety fence to the respec-
tive tool diameter and the desired chip re-
moval.
•
Adjust the front, horizontal pressure piece
(
1
) to the width of the workpiece and the
rear, vertical pressure piece (
2
) to the
height of the workpiece.
Remark
: The two pressure pieces must
form a tunnel through which the workpiece
is pushed. Therefore, the adjustment must
be made in such a way that the workpiece
can be pushed through by hand under light
pressure.
When not in use (e.g. when milling with a power feeder), the device is simply folded upwards. To do this, pull out
the locking bolt (
3
) on the ball handle and swivel the device upwards until the locking bolt engages again.
If no power feeder is used for milling, a protective and pressure device must be used.
17.2
Protective and Pressure Device
CENTREX 1624
The fold-up protective and pressure device CENTREX 1624 is used to securely fix workpieces during manual mill-
ing operations. It can be attached to all common safety fences and is used instead of the standard protective and
pressure device. The special shape of the pressure shoes ensures precise workpiece guidance for all milling work.
Figure 27: Protective and pressure device CENTREX 1624
•
First adjust the safety fence to the respective
tool diameter and the desired chip removal.
•
Then loosen the clamping wheel (
3
) and (
4
)
and put the pressure shoe (
2
) upwards.
•
Adjust the pressure shoe (
1
) to the workpiece
width, pretension and tighten the clamping
wheel (
3
).
•
Adjust the pressure shoe (
2
) outside the knife-
edge circle to the height of the workpiece,
pretension and tighten the nut (
4
).
•
Adjust the pressure shoe (
1
) to the workpiece
height for milling wide or flat workpieces and
for milling end faces.
When not in use (e.g. when milling with a power feeder), the device is simply folded upwards. To do this, pull out
the locking bolt (
3
) and swivel the device upwards until the locking bolt engages again.
If no power feeder is used for milling, a protective and pressure device must be used.
3
2
1
5
4
3
2
1
