BA_WP_SPM2-1000_EN_28-22.docx
42
16.1.2
Folding up the protective bonnet
Figure 23: Fold up protective bonnet
To open the protective bonnet, proceed as follows:
•
Loosen the fixing screw (
V
).
•
Fold the protective bonnet (
H
) upwards.
Increased danger of drawing in, cutting, kick-back and
ejection at the tool when the protective bonnet is open!
16.2
Optional Safety Fence “PANHANS Type 215”
Features:
•
Solid safety fence for tool diameters up to 250 mm in proven PANHANS quality.
•
The total fence is adjusted by handwheel and the partial fence by means of an adjusting screw.
•
The fence is equipped with cast iron stop plates, aluminium splinter tabs and a tool cover.
•
A separate measuring device is required to position the total fence (e.g. setting gauge).
•
Retrofitting with integral fence plates (see section
17.5) is possible.
Figure 24: Components of safety fence type 215
With type 215, the total and partial fence are
manually adjustable. For adjustment, the clamp-
ing levers (
3
) and (
6
) are released and the fence
is adjusted via the hand wheel (
2
). Afterwards
the two clamping levers (
3
) and (
6
) must be re-
tightened.
The partial fence on the right
side can be adjusted by the ad-
justing screw (
5
) and read off on
the vernier scale.
To adjust the total fence via hand-wheel, a sep-
arate measuring device is required (e.g. setting
gauge or similar).
Pos. Description
Pos. Description
1
Total fence plate (multiplex)
7
Splinter tabs
2
Total fence handwheel adjustment
8
Clamping star grip for fence plate adjustment
3
Total fence clamping lever
9
Sliding covers for high tools
4
Partial fence plate (multiplex)
10
Knurled screws for tool covers (
9
)
5
Partial fence adjusting screw
11
Milling protection & pressure device
6
Partial fence clamping lever
12
Protective hood (unlocking rear left)
Note:
The star grips (
8
) as well as the partial fence adjustment screw (
5
) are located on the rear side.
16.2.1
Fence plate adjustment
Loosen star grip (
8
) and push the fence plate (
1
) to the desired position. Then retighten star grip (
8
). Always ad-
just the plates so that they cover as much of the tool as possible without touching it.
16.2.2
Fit a grooved board or safety rulers
To insert a grooved board or safety rulers, remove the splinter tabs (
7
), attach the grooved board or safety rul-
ers as fence bridges and fasten them via the free threaded holes.
V
H
2
4
1
6
3
12
7
8
5
11
9
10
