BA_WP_SPM2-1000_EN_28-22.docx
40
14
Sliding Table
The lockable sliding table provides valuable support during milling work and ensures more flexibility and safety
during machining. It enables more precise work, accurate guidance of the workpiece and a straight course of
the milled surface.
Figure 17: Operating the sliding table
Operating the sliding table:
•
To lock the sliding table, push the locking lever (
A
) to the
lower position.
•
To move the sliding table, set the locking lever (
A
) to the up-
per position and move the table with the handle (
H
) or the
push bar (
S
).
Remark 1:
If the sliding table is not used to guide the work-
piece, but only as a support, it must be locked in place.
Remark 2:
If the sliding carriage is used to guide the workpiece, it is recommended to use it in combination with
the telescopic fence whenever possible and to fix the workpiece on the working surface with the eccentric clamp.
15
Telescopic Fence
The adjustable telescopic fence (900 mm) has two flip stops, a protective cover and an eccentric clamp for fixing
the workpiece. It is used in combination with the sliding table for precise and safe workpiece guidance and can
also be used as a kickback guard.
Figure 18: Operating the telescopic fence
Pos. Description
F
Clamping wheels for flip stops
M
Ruler with millimetre scale
W
Clamping lever and angle adjustment
S
Reading scale for angular degrees
V
Vertical adjustment of eccentric clamp
H
Horizontal adjustment of eccentric clamp
E
Clamping lever for eccentric clamp
P
Protective cover
•
The telescopic fence is fixed in the groove of the sliding table via the clamping lever (
W
).
•
At the same time, the clamping lever (
W
) is used to adjust the angle of the telescopic fence.
•
The set angle can be read off the angle scale (
S
).
•
The two clamping wheels (
F
) are used to adjust and clamp the two flip stops.
•
The position of the flip stops is set on the millimetre scale (
M
).
•
The eccentric clamping lever (
E
) is used to fix the workpiece on the sliding table.
•
The eccentric clamp can be adjusted in height by loosening the lever (
V
) and can be rotated around its own
axis if necessary. The lever (
H
) can be used to adjust the eccentric clamp horizontally.
•
Important:
When adjusting or turning the eccentric clamp, make sure that it does not touch the fence plates
of the safety fence and set a sufficient distance to the safety fence.
H
A
S
S
W
F
H
V
M
E
P
