34
1/8" gap between set
washer and frame
8) Secure the rear frame to the pillars with one #6 x 1" screw through the hole in each end of the
frame.
9) Lay the clock down, front side up. Route the short cord from the larger diameter weight spool
hub over the pulley in the lower pillar. Then route this cord through the weight pulley and back up
to the pillar, tying off the cord in the hole in the bottom of the lower pillar. Make sure the weight
pulley hook is oriented as shown below. Be sure the knot is secure since it will be supporting the
weight shell.
10) Place a set washer on the great wheel arbor that extends through the front frame. Locate the set
washer so that there is about 1/8" of clearance between the frame and the set washer.