33
5) Insert the winding guide arbor, short portion of the arbor down, into the endmost 1/4" hole in the
rear frame.
6) Insert the minute arbor unit through the lowest hole in the front frame unit (this hole contains a
nylon shoulder washer on both sides, installed previously). The 30 tooth gear should be on the
interior side of the frame (the same side as the pillar). Slide two spacer washers onto the arbor
protruding through the front of the frame and complete by installing the remaining 8-tooth gear on
the arbor. Adjust the position of the spacer washer and/or 8-tooth gear so the arbor can spin freely
in the bushings.
7) This might take a little patience. Carefully attach the front frame unit. Note that the escape
wheel arbor and great wheel arbors extend through the front frame. Line the arbors up with the
bushings as the frame front is applied. The dowels protruding from the pillars engage with the
corresponding holes in the rear frame.
