31
Setting-Up the Template Holder
Assembling and aligning the
template holder is fast and easy.
Using the template holder, with
it’s centering holes and centering
scale is even easier than ever.
Just push the guide bearing shaft
through the template into the
hole in the template holder and
it’s lined-up dead center
Decide whether to use the inch or
metric scale for centering. Place
that side of the template holder
up.
Stick a piece of the UHMW
low-friction tape on either side of
both slide rails.
Assemble the holder keeping all
screws loose. They’ll be tightened
after the assembly is aligned to the
support frame.
Place the smoother side of the
stamped slider nuts (lower in
photo) facing the lever knob.
Align the slide rail to the top of
the support post then tighten the
lever knob.
Align the template holder extru-
sion to the slide rail then tighten
the screws.
Use a 4mm or 5/32” hex wrench
for the cap screws.
Use an 8mm or 5/16” end wrench
for the acorn nuts.
The intersection of the template
holder support post, the slide rails
and the template holder extrusion
should be flush.
