18
Setup trick for perfect pins
Transfer the tails layout
. You change the fit
of the pins by moving the template holder
up (tighter) or down (looser), which moves
all the templates along with it. To dial in the
fit from the get-go, try the following. Clamp
a tails board to the top of the PantoRouter
TM
table as shown, and use the supplied clamps
to attach pins test board vertically, aligned
with the board above. Then scribe part or all
of the tails layout onto the pins board test
piece.
Mount the pins test piece on the table then
dial in the template height.
Holding the
bearing against one side of a template, move
the template holder up and down until the
router bit is perfectly aligned with part of
your pins layout. Lock the template holder
at that height.
