Setup & Operation
Cutting – Stack Mode
EGdoc013119
4-25
4
If the Automatic Set option is disabled, push the right drum switch downwards when the log reaches the start of
the log.
At any time it is possible to remove the settings of the start/end of the log and the cut by short pressing the
NEXT CUT button on the operator's panel.
4.2.16
Cutting – Stack Mode
Use the Stack cutting mode to perform a series of cuts counted from the log bed.
The controller allows setting a program for cutting a log into boards of any thickness, calculating the quantity of
boards that can be cut from the log bed. The Stack mode does not require entering all the values of the board
thickness one by one – program positions are automatically filled with the same currently selected value from
the current field upwards. At the same time, it is possible to change the value of any program position.
The controller allows setting four custom cutting programs and saving them in the memory. Thanks to that,
it is possible to recall quickly a program with frequently used cutting sizes, which allows saving
the time needed for modifying the cutting program each time.
The operation in the Stack mode is described below. Also a sample program enabling the cuts shown below is
presented.
Before cutting, create a program in the Stack mode setup.
To do this, press the STACK MODE button on the manual mode screen. Then press the STACK SETUP
button.
FOT. 4-17
50mm
40mm
30mm
25mm
25mm
25mm
25mm
Cut 3
Cut 4
Cut 2
Cut 1
Cut 5
Cut 7
Cut 6
Summary of Contents for Titan WB2000-EC
Page 1: ......
Page 2: ......
Page 30: ...Setup Operation Sawmill Setup 4 4 4 EGdoc013119 FIG 4 3 WB2000 hes_017_A Lifting brackets...
