SETUP & OPERATION
Blade Height Scale
2
2-22
25doc092506
SETUP & OPERATION
2.14 Blade Height Scale
See Figure 2-13.
The blade height scale is attached to the cutting head frame. It
includes:
a blade height indicator
an inch scale.
Blade Height Indicator
The blade height indicator has two horizontal, red lines on both sides. Readings should
be taken with eyes level with the indicator, when the two red lines are in line. This will
allow to avoid the parallax error (different scale readings depending on the angle of
vision).
The Inch Scale
The horizontal red line on the blade height indicator shows how many inches the bottom
of the blade is above the bed of the mill. If you know the height of your blade at each cut,
you can determine the thickness of lumber you are sawing.
Example
: You want to cut 1” (25 mm) random width boards from a log. Position the blade
for the first cut. Move the carriage to an even measurement on the inch scale. Make a
trim cut. Return the carriage for the second cut and lower it 1 1/8” (28 mm) below the
original measurement. (The extra 1/8” (3 mm) allows for saw kerf and shrinkage of the
lumber.)
The yellow area on the scale identifies where the blade could encounter a side support or
log clamp. Check that these items are below the blade level before sawing.
FIG. 2-13
Quarter
Scale
1 6
1 7
1 8
1 4
4
4
4
5
5
5
5
6
6
6
8
1 5
4
8
Inch
Scale
Blade Height
Indicator
