SETUP & OPERATION
Loading, Turning, And Clamping Logs
2
2-14
25doc092506
SETUP & OPERATION
See Figure 2-9.
3.
Make sure the side supports are positioned low enough for the blade to pass over them. If
they are not, back the clamp off slightly and push the side supports down until they are
positioned below the level of your first few cuts.
4.
Use the toe board levers to level the log if desired.
To Level A Tapered Log:
Use the toe board levers to raise either end of a tapered log, if desired.
FIG. 2-9
Log Clamp
Side Support
