Debarker Installation
Debarker Installation
DB17doc072219
3-1
3
SECTION 3 ALIGNMENT
DANGER!
Before performing any service to this equip-
ment, turn the key to the OFF (0) position and remove the
key. Failure to do so will result in serious injury or death.
The debarker blade should be aligned to the sawmill blade to insure proper operation.
The debarker blade should be parallel with and aligned vertically with the sawmill blade.
1.
Turn the key to ACC (3) and use the debarker in/out switch to move the debarker all the
way in. Turn the key to OFF (0) and remove the key. This will prevent the debarker from
being turned on while performing alignment procedures.
2.
Check the squareness of the debarker with the sawmill blade. Adjust the debarker
mounts if necessary until the debarker is square with the sawmill blade.
Loosen the debarker upper/lower mounting bolts and loosen the jam nuts on the
upper/lower adjustment bolts. Turn the adjustment bolts as necessary until the debarker
is square with the sawmill blade. Retighten the jam nuts and debarker mounting bolts.
See Figure 3-1.
FIG. 3-1
LX0042-6
Loosen jam nuts
and adjust bolts
to square debarker
with sawmill blade
Loosen
mounting
bolts