Debarker Installation
Harness Installation
Debarker Installation
DB17doc072219
2-6
2
2.
Cut the conduit of the in/out motor wire harness to expose the quick connect terminals.
Remove the rubber cap from the in/out motor and install the removed conduit around the
in/out motor wires. Route the wires down the side of the in/out motor to the quick con-
nects. Be sure to leave slack in the harness to avoid kinking and bending as the debarker
moves in and out. Replace the motor cap and secure the harness to the in/out motor by
connecting two wire ties together and wrapping around the motor.
3.
Connect the in/out motor wire harness to the in/out motor saw head harness. Secure the
harness to the blade motor frame with wire ties.
4.
Route the warning light harness on top of the blade motor pivot arm to the debarker blade
motor. Secure the warning light wires to the pivot arm with wire ties as shown above.
See Figure 2-5.
5.
Remove the top nuts from each of the motor terminals.
FIG. 2-5
+
-
Install rubber
boots and ring
terminals (See detail)
Connect black wires to
(-) terminal;
red wires
to (+) terminal
LX0042-5B