Debarker Installation
Harness Installation
2
2-5
DB17doc072219
Debarker Installation
2.2
Harness Installation
DANGER!
Before performing any service to this equip-
ment, turn the key to the OFF (0) position, remove the key,
and disconnect the sawmill battery ground terminal. Failure
to do so will result in serious injury or death.
IMPORTANT!
Avoid pinch and pivot points, unnecessary
wire bending and open spaces where the wire could get
caught by a log, etc. If you have any questions, call
Wood-Mizer customer service.
1.
Route the harnesses through the saw head frame hole as shown. Continue routing the
long blade motor wire harness (large wires/ring terminals) inside the debarker frame
through the three holes with grommets.
See Figure 2-4.
FIG. 2-4
+
-
Blade
Motor
Wires
Warning Light
Wires
Connect In/Out
Motor Cable
To Debarker
Harness
Install Ring Terminals
To Warning Light Wires.
Install Boots Over
Light And Motor Wires
And Connect To Debarker
Blade Motor
Red/+, Black/-).
LX0042-4B