Maintenance and Alignment
Replacing the Blades
5
5-1
EGdoc020420
Maintenance and Alignment
SECTION 5 MAINTENANCE AND ALIGNMENT
WARNING!
Before performing any service near moving parts such as:
blades, pulleys, motors, belts and chains, first turn the main switch to
the "0" position and then disconnect the power cord.
WARNING!
Always shut off the motor/engine and allow all moving
parts to come to a complete stop before removing any guards
or covers. Do NOT operate with any guard or cover removed.
5.1
Replacing the Blades
Replace the blades if necessary. Dull blades will cause the motor/engine to work harder and will
result in decreased cutting quality and accuracy. Blade life will vary depending on maintenance of
the machine, operator as well as species and condition of wood being sawn.
DANGER!
Before changing the blades, make sure the mounting
bushings of the blades have come to a complete stop and the
motor/engine is shut off. Turn the main switch to the "0" position and
disconnect the power cord. Failure to do so may result in serious injury.
WARNING!
Always wear safety goggles, gloves and foot protection
when handling the blades.
CAUTION!
Before installation of the blade, inspect it for damage and
cracks. Use only properly sharpened blades. Be extremely careful
when handling the blade.
1.
Open the blade cover.
2.
Using a 24 flat wrench, lock the blade shaft (A) and remove the blade nut (B). (Turn left to remove the
fixed blade nut; turn right to remove the movable blade nut.)
