INSTALLATION
Edger Setup
Operation
EGdoc020420
3-1
3
SECTION 3 INSTALLATION
3.1
Edger Setup
IMPORTANT!
Before starting to use the edger, you have to meet the
following conditions:
Setup the machine on firm and level ground.
When your EG100 edger is used indoors, it must be operated with a sawdust exhaust system
connected.
The EG100 edger equipped with an electric motor must not be used outdoors when it is
raining/snowing. In such a case, the machine must be placed under a roof or indoors.
The EG100 edger with a gas engine must be used outdoors. It can be operated without
a sawdust exhaust system connected. To protect the operator against exhaust gases and
sawdust, we recommend that the machine be setup so that the operator does not stand against
the wind.
The machine should work in temperatures of –15
o
C to 40
o
C (5
o
F to 104
o
F) only.
The light intensity in the operator’s work-place must be 300 lux
1
.
The work-places for two operators of the edger are shown in the figure below.
See Figure 3-1.
1 The light source cannot cause the stroboscopic effect (PN-EN 12464-1:2012).
FIG. 3-1
!
