Introduction to the DVR Function (Rapport III-Pro) ( )
1. Selecting the DVR mode causes the DVR (
Rapport III- PRO
) to initially boot
up and after 2~3 seconds the start menu is displayed.
EMPTY : No SD card installed.
IN : SD card has been installed.
SET
VIDEO :
Indicates if the input or output video signal system is NTSC or PAL. Input video
signal is output onto the LCD screen and automatically switches to NTSC or
PAL without using a special setup key. The output video signal when in Pattern
Generator mode can be switched to NTSC or PAL, using key.
Indicates screen brightness, and brightness increases by +1 when the
key is pressed, and decreases by -1 when the key is pressed.
It returns to the initial setup value when either of the two keys is depressed
for more than 3 seconds.
NEAR
FAR
Indicates screen contrast, and contrast increases by +1 when key is
pressed, and decreases by -1 when key is pressed. It returns to the initial
setup value when either of the two keys is depressed for more than 3 seconds.
TELE
WIDE
The Video Level should be within the indicated range.
Levels that are too low will result in a dim picture with reduced dynamic range.
A Video Level that is too high will result in washed out pictures with decreased
definition.
The Sync Level controls the drawing of each line on the monitor. Sync Levels
that are too low will cause the picture to breakup or roll while Sync Levels that
are too high will result in a picture with reduced grey colours and dynamic range.
In an installation with multiple cameras, the video and sync levels should be
matched as closely as possible at the head-end to prevent noticeable picture
quality differences when switching between cameras on a sigle monitor.
Values outside the recommended tolerances can cause the operators to
experience eye fatigue.
24
MULTI FUNCTIONAL CCTV TESTER
25
MULTI FUNCTIONAL CCTV TESTER
FUNCTIONAL SPECIFICATION
FUNCTIONAL SPECIFICATION
BRIGHT 07
CONTRAST 07
①
DVR MODE : : Indicates DVR Mode
②
NTSC : Indicates NTSC or PAL System
③
Indicates Screen Mode. Shows REC (
●)
when in record and PLAY(
▶)
when in
playback, otherwise will display LIVE for real time images.
④
FILE NO : Idicates recoded file number.
⑤
C
DVR
NTSC
DVR Booting...
C
DVR
NTSC
FILE : 1
IN
SD
C
DVR
NTSC
FILE : 1
IN
SD
RapportIII-Pro supports the DVR function.
⑥
MODE : Change the mode.
METER
VIDEO
PTZ
CABLE
SETUP
DVR
①
③
④ ⑤
⑥
②
MODE
