Part
Function
Description
①
Type of Test Set Up
- Resistance Test
- Continuity Test
- DC and AC Voltage
②
Test value
Displayed
- Unit of resistance Test
- Indicates either the AC or DC Voltage Range
- AC Voltage is indicated as RMS
(Root Mean Square) Values
③
Measured Graph
Value
- The Measured Input value is Displayed in the
Form of a Graph
The Graph is Changed Automatically and is
Equal to the Measured Value
OVER is Displayed When the Measured
Value is Higher Than the Setup Value
④
Measured Value
on Hold
The Measured Value is Stored and Displayed
Here When the SET Key is pressed.
⑤
MODE Display
Digital Multimeter Mode is displayed
⑥
DC
DC Voltage Test
AC
AC Voltage Test
OHM
Resistance Test ( Measuring Unit : Ω )
VOLT
Voltage Test ( Measuring Unit : V )
BUZZ
Continuity Test ( Starts to beep when below 80Ω )
Description of Meter Function LCD Window
Digital Multimeter
Voltage, resistance and continuity can be tested.
To prevent electric shocks, injury, or damage to the Rapport III, disconnect
the power supply to the circuit under test, and discharge all high-voltage
capacitors before testing resistance and continuity.
When using the meter function of the Rapport III, make sure the unit is switched
on and set to the appropriate test mode before connecting the test lead
set to the circuit under test.
W A R N I N G
Press the button to measure resistance; pressing the
button changes from the OHM scale to BUZZER (for continuity testing).
Press the button to measure voltage; pressing the
button causes the measurement range to toggle between ACV and DCV.
CLEAR
AC DC
/ /
CLEAR
AC DC
/ /
V
OPEN
CLOSE
Setup Keys
W A R N I N G
1. DO NOT unplug the SD card during recording.
2. Stop recording or playback before powering off the system.
3. DO NOT use the DVR function when there's a Low Battery warning.
34
MULTI FUNCTIONAL CCTV TESTER
35
MULTI FUNCTIONAL CCTV TESTER
FUNCTIONAL SPECIFICATION
FUNCTIONAL SPECIFICATION
DCV -0.000V
DCV--0.001V
METER
LOSS
MODE
STORE
VOLT
DC
BUZZ
AC OHM
①
②
④
⑤
⑥
