Mode setup
Video Tester Mode :
This function displays the image of an externally input video signal, or is used
to output internally generated signals when in PATTERN GENERATOR mode.
DVR MODE (
Rapport III-PRO only
) :
Used to record (onto SD Card) and playback input video images.
Digital Multimeter mode :
Tests voltage, resistance, & continuity.
PTZ Controller mode :
This function allows up, down, right and left movements of a PTZ camera
to be made. Also, zoom & manual focus can be adjusted.
UTP Cable Tester mode :
Tests UTP cable connectivity – tests for straight & crossed cables, for breaks
and short circuits.
Main Setup mode :
This function allows changes to be made to the basic setup of the Rapport III.
(user name, auto power off time, beeper etc.)
The MODE SELECT menu is displayed when key is depressed and moves
to the next menu whenever the key is pressed
MODE
MODE
The OSD menu changes whenever the key is pressed, and sequences
through in the following order : VIDEO – METER – PTZ - CABLE - SETUP
MODE
Power ON/OFF
Use a DC12V Power Adapter and connect it to the DC Jack. Turn the Rapport III ON/OFF
by using the slider switch located on the side of the product. After switching the
power switch to the ON position, press the OSD button and the Rapport III will boot
up. To turn the Rapport III OFF, keep the OSD button depressed for at least 2
seconds and wait until a POWER OFF message is displayed on the Main Screen.
Release the OSD button and turn off the ON/OFF slider switch; power is now turned off.
If the battery indication shows less than you need to recharge the battery.
(Full recharge state: )
After the power is applied the above on-screen message is displayed.
Approximately 2 seconds later the screen switches to the last OSD before power
was turned off. The Rapport III stores the last accessed OSD.
The initial OSD message displays the Rapport's firmware level. Versions of the
product change whenever new firmware is uploaded.
When charging the battery, keep it on charge for more than 6 hours or until the
unit is fully charged. On full charge the operational time is approximately 6 hours.
(Max.8hrs)
Initial Screen Display at Power On
MULTI FUNCTIONAL CCTV TESTER
20
21
MULTI FUNCTIONAL CCTV TESTER
FUNCTIONAL SPECIFICATION
FUNCTIONAL SPECIFICATION
RAPPORT
RAPPORT III
FW Version : 0.30
SETUP
LOSS
METER
VIDEO
PTZ
CABLE
SETUP
USER NAME : RAPPORT-III
SLEEP TIME: 5Min
BUZZER : ON
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
