WMD Metron, User Manual

Page: 39 / 51

8. SETTINGS
8.1 TEMPO AND SHUFFLE
Access Metron’s Internal Clock settings by holding [TEMPO] and turning
the encoders. ENCODER 1 changes TEMPO. ENCODER 2 changes SHUFFLE
AMOUNT. Quickly set Metron back to 50% shuffle by pressing [ENCODER 2].
The clock input can also be switched between Internal and External in this
mode by pressing [ENCODER 1].
The Internal Clock TEMPO, and SHUFFLE settings are saved with
session memory. See MEMORY section 4.9 for more info.
8.2 GLOBAL SETTINGS
Metron offers a number of Global Settings that allow the user to further
refine their experience while using Metron. Access Global Settings by pressing
the [GLOBAL] button. Use ENCODER 2 to select the setting, and ENCODER 1 to
change the setting’s value.
Clock Internal / External Set the clock to Internal or External*.
Character Format Display time in decimal* (base 10) or hex
(base 16 [0-F])
Trigger Length Time length of a single microstep. 1ms, 2ms, 4ms,
8ms, 1/36th clock, 1/12th clock*. Note: Triplet 1/12th
is technically equal to 4/36th
S.BUS Setting Master, Slave, or Off*
Init Settings Initializes all settings to factory default. Does not
touch saved sessions
Reset Input Determines whether the reset input responds to a
normal trigger*, or expects a din sync style start/
stop signal to run.
Reset Output END* sends a reset signal at the end of the
variation. RST sends a trigger only when a Reset
signal is received. Set to RUN, the output stays
high. Pulses low when a reset signal is received.
Firmware Version Displays your current firmware version.
Force Update Reboots to the bootloader if a valid “UPDATE.bin” is
present on the memory card.
8. SETTINGS
38
*Default Setting