5
WT-1011RC IP65 GSM Remote Controller And Alarm System
WT-1011RC IP65 – USER MANUAL – Rev.1.6 – Technical Support:
COPYRIGHT ©2010 WITURA CORPORATION SDN BHD
Relay 1 can turned on for a preset time by calling its number and Relay 2 can be
activated by text messages from mobile phone. Creating action messages are done with
the same ease as that of input monitoring.
Authorized groups can also query the status of an input or output. This is very useful
feature to determine the present status of an input or output. The enquirer need not
wait for an alarm to happen in order to receive the given I/O status.
Authorized users can send a SMS command to trigger on or off the digital output. Upon
receiving the command, WT-1011RC will perform the instructed action. After the on or
off action is done, it will send a reply to the querying mobile phone as an
acknowledgement.
WT-1011RC has a feature to allow user to remotely add, change or delete any mobile
phone numbers in WT-1011RC memory.
Re-assigning of operation personnel, a change of mobiles phone number is also
common. Rather than having to physically go to the installation site with a notebook
computer, the authorized personnel can perform the change from anywhere using
mobile phone. Where there are many installed sites, this feature saves time and afford.
Authorized mobile phone group can perform system check by sending a command to
WT-1011RC. If WT-1011RC is switched on or working normally, it will reply to the
querying number.
Integral to the design of WT-1011RC is a GSM 850/900/1800/1900Mhz Industrial
grade modem. Its capabilities and performance are highly optimized by the operating
firmware. Any change in the GSM signal and receiving conditions are detected quickly
and the software automatically takes care of signal errors
3.4 Querying Inputs And Outputs Status
3.5 Turning On / Off Device Remotely
3.6 Remote Editing Of Mobile Phone Numbers
3.7 System Check
3.8 GSM Modem
