Wisstar WP-N6516-E2, User Manual

Page: 150 / 215

Network Video Recorder User Manual
149
11.1.3 Configuring NTP Server
Purpose:
A Network Time Protocol (NTP) Server can be configured on your NVR to ensure the accuracy of
system date/time.
Step 1 Go to Menu > Configuration > Network > NTP.
Figure 11-6 NTP Settings Interface
Step 2 Check Enable NTP.
Enabling NTP will disable cloud server time sync.
Step 3 Configure the following NTP settings:
Interval: Time interval between the two synchronizing actions with NTP server. The unit is
minute.
NTP Server: IP address of NTP server.
NTP Port: Port of NTP server.
Step 4 Click the Apply.
The time synchronization interval can be set from1 to 10080min, and the default value is 60min.
If the NVR is connected to a public network, you should use a NTP server that has a time
synchronization function, such as the server at the National Time Center (IP Address:
210.72.145.44). If the NVR is setup in a more customized network, NTP software can be used to
establish a NTP server used for time synchronization.
11.1.4 Configuring SNMP
Purpose:
For certain models, you can use SNMP protocol to get device status and parameters related
information.
Step 1 Enter the Network Settings interface.
Menu >Configuration> Network
Step 2 Select the SNMP tab to enter the SNMP Settings interface, as shown in Figure 11-7.