WPS-300-NVR Installation Manual
Pg. 59
www.snapav.com Support: 866.838.5052
14.4.5-
When an FTP server is configured, recorded video and snapshot files can be stored on the
server for later access. Contact the network administrator for FTP server information.
Enable
Alarm
Notifications will be sent when an alarm event
occurs.
Motion
Notifications will be sent when a motion event
occurs.
Note:
When NVR Record mode is Schedule, and FTP Schedule is
configured for Alarm FTP, Motion FTP or Both, these check boxes will
become checked and cannot be un-checked unless FTP Schedule is
changed to No FTP, or Record Mode is changed to Manual, or Alarm
Trigger.
FTP Server
FTP Site address. This is usually the same as one would use to access
the FTP site from a browser or FTP client.
Username
Username used to log into the FTP Site.
Password
Password used for the Username account on the FTP.
Port
Port to use for FTP connection. This is usually 21.
Path
Directory on the FTP site to store content.
Note:
We recommend using path names containing only letters, numbers
and underscores to ensure reliable communications.
Example: /ALARM/, /ALARM123/ or /ALARM_123/.
14.4.6-
The NVR can be used as a DHCP server for network devices. This should be used for network
devices other than Wirepath IP surveillance devices as they should be a static IP address, and
only when a network Router is not present in the system.
Enabled
When selected the NVR can be used a DHCP server.
Start IP Address
Address to start for issuing IP addresses.
End IP Address
Address to end for issuing IP addresses.
Lease Time
The amount of time to lease the IP Addresses.
14.4.7-
When enabled, allows for automatic configuration of UPnP Port forwarding with compatible
routers.
Enabled
Select Enabled to allow the camera to be detected by computers using
UPnP.
External HTTP
Port
External network port to be configured by a compatible router to access
the Camera through HTTP.
