WPS-100-NVR-4IP Installation Manual
Pg. 36
© 2013 Wirepath™ Surveillance
12.3.1.5-
Motion Setup
Provides 3 areas (or All) to select for detecting motion on the Camera. When configured, an action such as record, take a photo, and
send notification will be performed after the motion is detected.
See step
3-Configure Motion Detection Areas
in section
11-Additional Configuration
for detail on how to configure motion detection.
Relay Dwell
Sets time from 1 to 99 seconds that the NVR relay output will toggle when a Motion event is detected.
When set to Off, relay will not toggle when Motion is detected.
Buzzer Dwell
Sets time from 1 to 99 seconds that the NVR internal buzzer will sound when a Motion event is detected.
When set to Off, buzzer will not sound when Motion is detected.
Area 1, 2, 3
Checkboxes
Select to enable the configured motion area(s).
Note that all three Areas will be displayed, even if the currently selected Camera or Encoder supports only
one or no Motion Areas.
Sensitivity
Adjusts the sensitivity level of the configured motion area (1 = Low, 10 = High).
Motion Area Setup
Select to open the Motion Area Setup window.
See step
3-Configure Motion Detection Areas
in section
11-Additional Configuration
Update
Updates the selected Wirepath Camera with the configured Motion settings.
Exit
Returns to the Camera menu.
12.3.1.6-
Privacy Mask Setup
Provides 3 areas to select for masking areas of the image to avoid unwanted viewing.
See step
2-Configure a Privacy Mask
in section
11-Additional Configuration
for details.
Area 1, 2, 3
Checkboxes
Select to enable the configured Privacy Mask area.
Note that all three Areas will be displayed, even if the currently selected Camera or Encoder supports only
one or no Privacy Mask Areas.
Motion Area Setup
Select to open the privacy Mask Area Setup window.
See step
2-Configure a Privacy Mask
in section
11-Additional Configuration
Update
Updates the selected Wirepath Camera with the configured Privacy Mask settings.
Exit
Returns to the Camera menu.
12.3.1.7-
NVR Audio Setup
Use to select the channels that will use Audio In and Audio Out. Select Save to save settings to the NVR, select Exit to return to the
Camera menu.
12.3.1.8-
Quick Setup
The Quick Setup menu allows for entry of IP Addresses, Ports, User names, Passwords, and selection of channels for Cameras to be
assigned to the NVR. Cameras can also be enabled or disabled from this menu.
Note:
Quick Setup currently requires knowing or obtaining the required information to enter for all Cameras or Encoders to assign in
this screen. The Wirepath IP Installer software utility will quickly and easily find and display this information for all connected Wirepath
IP Cameras and Encoders.
Select Save to save changes to the NVR, select Cancel to return to the Camera menu.
