![background image](http://html.mh-extra.com/html/wire-wizard/gas-tracker/gas-tracker_installation-and-operation-manual_988434008.webp)
6
GAS TRACKER INSTALLATION & OPERATION MANUAL
Inline (Fixed) Installation
1. Permanently mount the
Gas Tracker
using the mounting tabs and four holes on the top and
bottom of the unit. The unit should be mounted in a location far enough away from the work
area to avoid damage from weld spatter, and
a 100 – 240 VAC outlet is
also required (within 59
in (1.5 m)) for powering the unit. Having the
Gas Tracker
installed near the inlet of the solenoid
or past the outlet of the solenoid will increase accuracy of the peak gas flow readings.
2. Connect the
Gas Tracker
inline to the gas supply. The
Gas Tracker
shall
only
be used on the outlet
side of the gas regulator. Ensure the inline filter provided with the unit is installed on the inlet
side of the sensor.
3. The
Gas Tracker
is designed to accept ¼ inch NPT thread types. Any gas rated fitting with
the correct thread type is acceptable. The
Gas Tracker
is not sent with any hose barbs. These
must be supplied by the customer. ELCo recommends the use of teflon tape on all threaded
fittings. Upon installation, ensure the teflon tape does not cover the orifice of the fittings.
4. Ensure the
Gas Tracker
is installed with the gas flowing from left to right, as indicated with
the arrows on the front of the unit (Fig. 2).
5. Using the 24 V power adapter, plug in the
Gas Tracker
to a 100 – 240 VAC o
utlet. Ensure the
cord is not in a location subject to getting pulled or damaged.
Summary of Contents for GAS TRACKER
Page 2: ......