47
PRoGRAMMING SoFTWARe STARTING
(TAKeS WINDoW XP FoR eXAMPLe)
NoTe
The programming software of this transceiver is attached with product identifying system.
therefore,when you start programming software at the first time,you should connect the transceiver
and then you can run the software ,otherwise the software cannot be run.
1.Double click “WPS-301 setup.exe” and then go on installing as computer command.
2.Click “START” menu, choose “USB To Comport” in the WPS-301 entry from “ALL
PROGRAMS” and click it. Please install USB To Comport drive program as computer
command.
3.Please plug PC03 programming cable into uSB port in PC device and then connect
with transceiver.
4.Double click “WPS-301”shortcut operation or click WPS-301 item which under the
starting menu of ALL PROGRAMS
5. choose serial port “COM Port” as per computer command, then click” OK” to
start programming software. (It must install software firstly and then insert USB
programming cable.
Note:in one individual computer ,user need to choose different USB port
number when USB programming cable connected with different USB port.
To program frequency ,power on the transceiver firstly.Do not power on/off the
transceiver when it is connected with computer.Otherwise,the transceiver can
not read or write frequency well,if this condition happens ,please firstly close the
programming software,disconnect uSB connector from computer,then ,connect the
uSB connect with computer again and select the corresponding COM Port to start
the programming software .
So ,please power on the transceiver before connecting with the computer .Do not
reset the transceiver when the transceiver is connected with the computer .
(picture 1)
(picture 2)
